The Chen Hsong Group   简体中文|繁體中文|English

ShowCase

Application Of Case

Location:Home > ShowCase > Application Of Case

Application Of Case

Comparison of main differences between CBmold300 computer and Ai computer operation

You may be familiar with Ai computer but not so familiar with the CBmold300Beckhoff computer, a n...

UPVC SPECIAL-PURPOSE INJECTION MOLDING MACHINE

The plasticizing system is designed specifically to address UPVC molding characteristics.&nbs...

PET Injection Molding Machine

This is a plasticizing system that is specifically designed for PET molding.  To fulfill...

Testing the energy efficiency of the souvenirs at our open house

An open house was held in the Feng Xiang production plant on 5th December, 2012. The purpose of this...

Introduction to EuroMaster Series

Our European customers are consistently communicating a wish for both high machine performance and a...

Introduction to the NewAge Intelligent Control System

For the past few years, customers have expressed an increasing interest in a controller with high st...

Introduction to NewAge Intelligent Control System (continued 1)

Software: Task Cycle Time 0.2~1ms. 1.    Support servo system with close loop con...

Introduction to NewAge Intelligent Control System (continued 2)

6. Support speed and pressure characteristic curves output of injection and holding phases 7.&n...

Chen De Independent Servo System

Chen De developed its independent servo system to replace its existing fixed or variable pump system...